avrdude -p attiny13 -c usbasp -B10 -U hfuse:w:0xFF:m -U lfuse:w:0x75:m Error: program enable: target does not answer (0x01)I have a tube full of brand new surface mount ATtiny chips. I pull one out and use the clip to grab it. I get the same error the first few times, but after fiddling with the clamp, on about the fourth try I am able to both set the fuses and program the chip!
This may be the road I need to go down. I do have a hot air rework station now.
Tom's Light Info / [email protected]